Bookings through this site are not open yet; it is looking for a local Santa Clarita installer to work with. You can check typical prices below and ask to be notified.

TV Dismount and Re-Mount Service in Santa Clarita

Santa Clarita TV Mounting covers TV dismount and re-mount in Santa Clarita: taking a wall-mounted TV down safely, moving it to a new wall or a new address, and re-hanging it on the existing bracket or a new one — with the old holes patched and painted so the wall looks untouched.

See typical prices Typically from $40
(661) 424-7700 Voicemail

Bookings aren't open yet. Leave your name and number; your message is recorded, and you'll get one message when a local installer is available.

Illustration: a technician lifting a TV off its wall bracket during a relocation Illustration

TV dismounting and TV bracket removal in Santa Clarita, CA: in the estimator, taking down an existing TV adds $40–$89, and a take-down with a re-mount on drywall runs $139–$388 per TV, depending on its size. Use the estimator below for your own numbers.

Typical reasons for a dismount

Moving house within the Santa Clarita Valley; remodeling a room and repositioning the media wall; swapping a 55 for a 75 that the old bracket cannot hold; replacing a fixed bracket with a full-motion arm; returning a rental to move-in condition; or a TV that was mounted off-level or on drywall anchors that are failing.

Taking a TV down is the best moment to see how it was put up.

How a mounted TV comes down safely

Two-person lift

Anything over 55 inches comes off with two people — the panel is lifted straight up off the bracket hooks and set on a padded blanket, screen in.

Bracket removal and inspection

The wall plate is unbolted and the installer checks whether the lag bolts hit studs. If the previous installer used drywall anchors for a heavy TV, the homeowner gets shown, and the recommendation is to do the new wall into framing.

Patch and paint

Lag holes get filled with setting compound, sanded flush and primed; with the wall color on hand the patch is painted, otherwise it is left primed and ready.

Re-mounting at the new location

If the existing bracket fits the TV and the new wall, it is reused. If the TV is new or the bracket is a cheap single-stud model, a replacement is recommended and quoted. The re-mount follows the full process: stud finding, laser level, lag bolts or toggles, load test, cable tidy or concealment.

Situation Existing bracket What the wall needs
Same TV, new wall, bracket in good shape Reused New lag holes into studs; old ones patched
Bigger or heavier TV Checked against the new weight and VESA pattern; often replaced Rating re-checked at 1.5× the new TV
Fixed bracket swapped for full-motion Replaced Two studs or a backer plate
Old bracket held by drywall anchors Replaced or re-hung into framing Fresh holes into studs
Leaving a rental Removed and packed with the TV Holes filled, sanded and primed

Transport between homes

For a move within the valley the TV can travel in a padded TV transport box in the same trip — never face-down or unprotected in a moving truck.

TV bracket removal

Bracket removal is its own step after the screen is off the wall. The TV comes off the arm or the wall plate first — two people for anything 55 inches and up — and then the plate itself is unbolted. What comes out of the wall depends on how the bracket went in:

How the bracket was held What removal looks like What is left
Lag bolts into wood studs Bolts backed out with a socket Clean round holes, easy to fill
Toggle bolts in drywall Bolt out; the toggle drops inside the wall A wider hole, filled with a backer or patch
Plastic anchors Pulled or set flush and filled Torn paper face around each anchor
Sleeve anchors in brick Anchor nuts off, sleeves cut flush Holes in the brick or mortar joint

The used-brick fireplaces in 1970s–80s Saugus ranch homes and the brick fireplaces of older Valencia tracts are the walls where a removed bracket leaves the most visible marks, because brick does not patch like drywall. In Canyon Country condos, the HOA rules about wall penetrations that applied when the bracket went up usually apply to the patch as well.

Wall patch and paint after removal

After TV bracket removal the wall needs three things: fill, sand and paint. Lag and anchor holes in drywall are filled with joint compound in two thin passes, sanded flat and spot-primed so the patch does not flash through new paint. Texture is matched before the paint goes on — a smooth patch on a textured wall shows from across the room.

  • Drywall over wood studs (most Stevenson Ranch, Castaic and Valencia homes from the 1980s on): compound, sand, prime, paint.
  • Plaster over wood lath (Old Town Newhall bungalows): plaster-grade patching compound; ordinary spackle shrinks and cracks there.
  • Brick and stone: holes in the mortar are filled with a matching mortar or colored filler; holes through a brick face never fully disappear.

The estimator has no separate patch-and-paint line, so it is worth asking for it in writing with the take-down. Leftover paint from the original color gives the closest match; otherwise the whole wall section between corners is repainted.

TV dismounting and relocation prices

Prices from the estimator on this page, 2027 market ranges, not quotes:

Line in the estimator Typical range
Taking down an existing TV (added to the job) $40–$89
Take-down plus re-mount, 32–49 inch TV on drywall $139–$218
Take-down plus re-mount, 50–65 inch TV on drywall $159–$238
Take-down plus re-mount, 66–85 inch TV on drywall $189–$288
Take-down plus re-mount, 86 inch and larger TV on drywall $239–$388
New wall is steel studs +$20–$40
New wall is plaster and lath +$20–$40
New wall is brick or stone +$50–$80
New wall is exterior stucco +$60–$90
A new mount supplied (when the old one does not fit) +$40–$120

Patch and paint are not in the estimator and are agreed separately. Moving a TV between homes is priced as a take-down at one address and a mount at the other.

TV Dismount & Re-Mount — common questions

Can the holes from my old mount be re-used?

Only if the new bracket's pattern matches and the old lags hit studs. Otherwise fresh holes go into framing and the old ones get patched.

How much does TV bracket removal cost in Santa Clarita?

In the estimator, taking down an existing TV adds $40–$89, and a take-down with a re-mount is the per-TV mounting range plus that line. Patching and painting are agreed separately.

Is a TV dismounting service worth it for a small TV?

For a light screen on a simple plate, many owners do it themselves. Larger sets, full-motion arms, brick fireplaces and wires run inside the wall are where a second pair of hands and the right tools matter.

What happens to the old bracket?

It stays with the owner. A good bracket that matches the next TV's VESA pattern and weight can be reused; a cheap single-stud bracket is usually not worth moving.

Availability & price range Step 1 of 5
Running estimate—

TV Dismount & Re-Mount: check availability and price range

Bookings aren't open yet — tell us about the TV and the wall. You get a Santa Clarita price range on the next screen. Typical Santa Clarita Valley prices for one TV, labor only unless an option says otherwise. This is a market estimate, not a quote.

TV size

Check availability and your SCV price range

Typical prices by TV size and wall type, on the same screen. Bookings open here once a local installer is named on this site.

(661) 424-7700 Voicemail

Bookings aren't open yet. Leave your name and number; your message is recorded, and you'll get one message when a local installer is available.

Voicemail (661) 424-7700